Toshiba GR-200-5 Instruction Manual

Also see for GR 200 Series: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

6F2T0207 (0.01)GRE200 (5,6)- 515 -DPOS1 function (Function ID: 512001)Operate Cmd.with ILK† conditionSR0.1 – 50.0 s[DPOS01-CPW]Operate Cmd.without ILK† condition[DPOS01-LGCTRCON]FixedlogicCommand “Local-On-Control”ILK† condition (“ON”) passedDPOS01-CloseDPOS01IN_TMP_35512001 810301EE57User configurable condition (PLC#1 connection point)“DPOS01_OEC_OK_CSF”(512001 8003011E7F)& & 1≥&1≥ 1≥ &&Input OutputOperate logic in DPOS01To BO connection“DPOS01_OEC_OK_CS”(512001 8103011E82)[DPOS01-PLSM]*FixVarOperate Failed[DPOS01-RST]“DPOS01_OEC_OK_CSF”“DPOS01_EX_FFL” ††(512001 8603011E91)To “Wait for a command”&Detection of state-change in a device&DPOS01IN_TMP_42512001 820301EE5EUser configurable condition(PLC#2 connection point) 1≥&“DPOS01_EX_CMP”(512001 8003011E93)Operate CompletedOperate condition‡Fixedlogic[DPOS01-LGCFEXOT]Assign to BOs&“DPOS01_OEX_BO” §§(512001 8203011DD3)To BO connection1.0s- 100.0s0 tFigure 4.2-24 Operate On on the front panel in DPOS01†††Note:The ILK function can provide the operation criteria for “On”.‡Note:An “operate condition” signal is generated in the operate-condition logic (seeFigure 4.2-31), when Fixlogic is set for scheme switch [DPOS01-LGCTRCON]. Ifan alternative “operate-condition” is required, it can be programmed by the userand used to replace the signal generated by the original operate-condition logic.The alternative “operate-condition” can be connected to the above usingconnection point #1” user configurable condition”. That is set the [DPOS01-LGCTRCON] to PLC and use “DPOS01IN_TMP_35”.§§Note: The “DPOS01_OEX_BO” signal is issued when Fixedlogic is set for schemeswitch [DPOS01-LGCFEXOT]. The “Operate completed” signal can also be issuedfrom logic programmed by the user in place of the logic shown in Figure 4.2-20.The user-programmed logic is connected internally to the signal “Operatecompleted”, hence this is now generated by the user-programmed logic atconnection point #2 “User configurable condition”. That is, set the scheme switch[DPOS01-LGCFEXOT] to PLC and use “DPOS01IN_TMP_42”.*Note:The user can set the type of output signal. When Var is set for scheme switch[DPOS01-PLSM], the output period of the signal is defined by the setting[DPOS01-CPW]. When Fix is set, the signal ceases when the 43-switch is changed.††Note: To identify the input and output signal-points of the other DPOS logics, see Table