Toshiba GR-200-5 Instruction Manual

Also see for GR 200 Series: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

6F2T0207 (0.01)GRE200 (5,6)- 402 -SBOwOperCancelOriginstSeldsboClass† (choice ”operate-once”)ctlmodel (choice ”SBOes or SBOns” )†”sboClass” can be found by scrolling down.Figure 3.6-2 LN editing screen for SBO mode (for example)Defining DIR modeFigure 3.6-3 exemplifies the settings in LN “LLNO” when the DIR mode is required for theMDCTRL01 function. In the DIR mode, the following three items should be selected using theGR-TIEMS:Operoriginctlmodel (choice ”DOes or DOns” )Figure 3.6-3 LN editing screen for DIR mode (for example)(ii) Mapping output dataThe user should group the MDCTRL01 signals with regard to GOOSE and REPORT; the usershould map them for the IEC 61850 communication using GR-TIEMS.Table 3.6-3 shows the required mapping signals in MDCTRL01 function to the IEC 61850communications. Figure below shows how to map a signal.Note: “Status (ST)” is defined in the function constraint (FC) of the IEC 61850 standard.