6F2T0207 (0.01)GRE200 (5,6)- 1120 -GRE200INF Semantics Contents GI TypeID COT Function_ID Data_ID51 Earth FaultFwd, i.e. lineEarth fault in theforward direction OK 1 1, 9 Not supported52 Earth FaultRev, i.e. busbarEarth fault in thereverse direction OK 1 1, 9 Not supported64 Start/pick-up L1 Relay operation inphase-A OK 1 1, 9 0x4A1001(TRCD)4A1001 8000001B71(OPT.PHASE-A)65 Start/pick-up L2 Relay operation inphase-B OK 1 1, 9 0x4A1001(TRCD)4A1001 8100001B72(OPT.PHASE-B)66 Start/pick-up L3 Relay operation inphase-C OK 1 1, 9 0x4A1001(TRCD)4A1001 8200001B73(OPT.PHASE-C)67 Start/pick-up N Relay operation inphase-N OK 1 1, 9 No default setting.68 General tripTrip operationperformed in thethree-phaseNA 2 1 0x4A1001(TRCD)4A1001 8300001B6F(GEN.TRIP)69 Trip L1 Trip operation inphase-A NA 2 1 No default setting.70 Trip L2 Trip operation inphase-B NA 2 1 No default setting.71 Trip L3 Trip operation inphase-C NA 2 1 No default setting.72 Trip I>>(back-up operation)Status on the OCrelay being inIDMT modeNA 2 1 No default setting.73 Fault location Xin ohmsFault locationdetermined (thecondition ofsending eventsare the same asthe FMR)NA 4 1Issued by GENERALCOMMAND function,which is described below.74 Fault forward/lineFault occurred inthe forwarddirectionNA 2 1 Not supported75 Fault reverse/busbarFault occurred inthe reversedirectionNA 2 1 Not supported76Tele-protectionSignaltransmittedSending a carriersignal NA 2 1 Not supported77 Tele-protectionSignal receivedReception of acarrier signal NA 2 1 Not supported78 Zone1 Zone1 trip NA 2 1 Not supported79 Zone2 Zone2 trip NA 2 1 Not supported80 Zone3 Zone3 trip NA 2 1 Not supported81 Zone4 Zone4 trip NA 2 1 Not supported82 Zone5 Zone5 trip NA 2 1 Not supported83 Zone6 Zone6 trip NA 2 1 Not supported84 Generalstart/pick-upThe OR signalgenerated byoperated relaysOK 2 1,9 0x453081(CBF_MV)453081 8B00011B27(CBF1_TRIP)85 Breaker failure CBF relay trip NA 2 1 same as the left