Toshiba GR-200-5 Instruction Manual

Also see for GR 200 Series: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

6F2T0207 (0.01)GRE200 (5,6)- 507 -DPOS01 function (Function ID: 512001)“DPOS01_ CC_SS”(512001_8603011E95)DEV01_CONTROL_REQ Cancel commandCommand “Remote-cancel”510001_7001016D08510001 7001016D08Input OutputCancel logic in DPOS01Cancel condition†&&Successes to cancelOperation Failed“DPOS01_CC_FS”(512001_8703011E96)“Do nothing”To “Wait for a command”Figure 4.2-15 ‘Cancel’ from the remote-end in DPOS01†Note: The “cancel condition” logic shall be seen in Figure 4.2-18.(ii) Receiving “Cancel” from the local-endFigure 4.2-16 depicts the cancel command procedure for a cancel command initiated from thelocal-end.Press cancelcommandCancel from the front panelDo nothingCanceldecisionSuccessFailedCancel logicWait for a commandOperate logicOperate commandOperate logicSelect logicsSelecting Off from remote-endSelecting On from remote-endSelecting Off from front panelSelecting On from front panelSelecting On by the PLC functionSelecting Off by the PLC functionCancel from the remote endWait for a next commandFigure 4.2-16 Outline of ‘cancel’ command from the local-endInput signal generated at the local-endFigure 4.2-17 depicts the cancel logic when a “Cancel command (Local-cancel)” signal is appliedto the DPOS01 function. The signal is generated when the “Cancel” key is pressed on the IEDfront panel; the user is not required to take account of mapping. When the logic receives the“Local-cancel” signal, the logic is able to output a result signal, provided that the “cancelcondition” checking is satisfied.