8. Holding Tray Assembly (overlay, re-pick up)9. Holding Tray Feeding AssemblyCHAPTER 11 TROUBLESHOOTING11-123COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CauseHolding trayfeeding clutch(CL1), Holdingtray feedingclutch (CL2)Holding trayfeeding assem-bly 1 papersensor (PS8),Holding trayfeeding assem-bly 2 papersensor (PS9)ChecksIs the holding tray feeding assem-bly set correctly?Does the paper move correctlyinside the holding tray feedingassembly?Are the holding tray feedingassembly 1 paper sensor (PS8)and the holding tray feedingassembly 2 paper sensor (PS9)normal?Step123YES/NONONONOActionSet it correctly.Replace the clutch (CL1or CL2).Replace the sensor (PS8or PS9).CauseHolding traypaper deflectingplateHolding traypaper deflectingplate solenoid(SL8)Holding trayreversing clutch(CL4)ChecksPerform the steps under 7.“Holding Tray.” Is the problem cor-rected?Is there deformation or scratcheson the holding tray paper deflect-ing plate?Does the holding tray paperdeflecting plate operate at the cor-rect timing?Does the roller rotation reverse atthe correct timing?Step1234YES/NOYESYESNONOActionEnd.Replace the paperdeflecting plate.Replace the solenoid(SL8).Check the wiring fromthe DC controller PCB tothe holding tray revers-ing clutch (CL4); if nor-mal, replace the clutch(CL4).
