F. Checking the Developing AssemblyCHAPTER 9 INSTALLATION9-17COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)WorkOpen the multifeeder tray.Open the multifeeder door, andremove the screw from the doortape.Remove the screw, and slide thedeveloping assembly locking unit inthe direction of the arrow (rear) toremove.Take the developing assembly out ofthe shipping box. Check the surfaceof the cylinder for scratches whileturning the developing cylinder gearby hand.Holding the center (grip pocket) ofthe developing assembly, install it tothe machine.Connect the connector.When installing the developingassembly, insert it from above sothat the developing cylinder willnot come into contact with themetal plate of the developingassembly mount.Step1234RemarksScrewScrewConnectorCaution:
