b. CassetteTurn the horizontal registration adjusting screw of each cassette, and makeadjustments so that the copy image and the edge of copy sheet is 0 ±1.5 mm when theTest Sheet is copied in Direct.1) Slide out the cassette, and loosen the two screws q and the locking pick w of theinside unit. (The cassette 4 is not equipped with a locking pick.)2) Detach the paper size plate of the cassette, and turn the horizontal adjusting screwwith a screwdriver e.Figure 11-2053-1 Adjusting the Left/Right Registration (paper deck-A1)1) Make a copy of the Test Sheet, and check to make sure that the left/right registrationbetween copy image and paper deck is 0 ±1.5 mm or less.2) If the left/right registration is not as specified, adjust the position of the latch plate ofthe deck opening solenoid by turning the two adjusting screws. (At this time, use thescale on the latch plate as a reference.)Figure 11-205a (rear left of compartment)ScrewsLatch plate Scale1132CHAPTER 11 TROUBLESHOOTING11-7COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
