6) Disconnect the connector q, andremove the two mounting screws w;then, remove the pre-exposure lampunit e.D. Blanking Exposure LampAssembly1. Removing the Blanking ExposureLamp Assembly1) Open the front door, and slide outthe hopper assembly.2) Disconnect the two connectors q,and remove the mounting screw w;then, slide out the blanking expo-sure lamp assembly e slowly.When removing the blanking expo-sure lamp assembly, take care soas not to damage the photosensi-tive drum.CHAPTER 4 IMAGE FORMATION SYSTEM4-43COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Figure 4-309q weFigure 4-310qqweCaution:
