D. Installing the AP Kit and the Charging AssembliesCHAPTER 9 INSTALLATION9-10 COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)WorkWhile pushing the rear (fixing/feeding assembly inside) of thereleasing lever locking shaft, shift upthe releasing lever. Remove the twoscrews, and remove the feedingassembly front cover.Remove the screw, and remove themetal fixing; then, disconnect theconnector. Holding the front and therear of the transfer/separationcharging assembly, pull theassembly to the front, and then pull itto the upper left to remove.Using alcohol, clean the transfer/separation charging assembly.Install the transfer/separationcharging assembly, connect theconnector.Install the metal fixing.Be sure to keep the transfer/separation charging assemblyin contact with the transferguide, and take care not todamage the gut wire.Further, be sure that thecharging assembly is fully dry.Step12RemarkswqMetalfixing Screw ConnectorScrewReleasing leverlocking shaft(rear)Feeding assemblyfront coverReleasingleverCaution:
