E. Installing the Copy Tray1. Replacing the Delivery Roller Leaf SpringWhen removing the stapler sorter or the sorter from the machine (i.e., to use the copytray), you must replace the two leaf springs of the delivery roller with leaf springs (weakerspring pressure) identified with a green sticker.When installing a stapler sorter or a sorter to the machine, check to find out if the twoleaf springs at the center are stronger than the two leaf springs on the sides; if so, do notperform the steps that follow.CHAPTER 9 INSTALLATION9-16 COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)WorkRemove the two screws, and removethe cover from the fixing/deliveryassembly.Remove the screw, and remove thetwo leaf springs (w/ rolls) at the center;then, separate the leaf springs and theroll.Fit the roll to the leaf spring that comeswith the machine, and install the leafspring to the fixing/delivery assembly.Install the cover to the fixing/deliveryassembly (2 screws), and slide in thefixing/delivery assembly into themachine, and close the front door.Step1234RemarksScrewScrewScrew
