COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV.0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)xii1. When copy paper is present atany of the sensors at power-on,end of wait-up, or duringstandby. ....................................8-182. Deck Pick-Up/Vertical PathDelay Jam.................................8-183. Deck Pick-Up/Vertical PathStationary Jam .........................8-18III. DISASSEMBLY AND ASSEMBLY ......8-19A. External Covers .............................8-201. Removing the Front Cover .......8-202. Removing the Vertical PathCover (rear) ..............................8-233. Removing the Right Cover .......8-234. Removing the Upper Cover......8-24B. Paper Deck ....................................8-261. Removing the Deck from theCopier .......................................8-262. Removing the Compartment ....8-283. Changing the Deck PaperSize...........................................8-304. Adjusting the Deck Registration ..8-315. Positioning the Roll...................8-31C. Drive System .................................8-321. Removing the Deck Pick-UpClutch (CL102) .........................8-322. Removing the Deck VerticalPath Clutch (CL101).................8-323. Removing the Deck MainMotor (M101)............................8-334. Removing the Deck LifterMotor (M102)............................8-345. Removing the Lifter Cable(deck front) ...............................8-356. Removing the Lifter Cable(deck rear) ................................8-377. Routing the Lifter Cable ...........8-39D. Feeding System.............................8-401. Removing the Deck Pick-UpUnit ...........................................8-402. Removing the Deck Pick-UpRoller ........................................8-413. Orientation of the DeckPick-Up Roller ..........................8-414. Removing the Deck FeedingRoller ........................................8-425. Orientation of the DeckFeeding Roller ..........................8-426. Removing the Deck SeparationRoller ........................................8-437. Adjusting the Deck SeparationRoller Pressure.........................8-448. Positioning the Deck Pick-UpRoller Releasing Solenoid(SL101).....................................8-44E. Electrical System...........................8-451. Removing the Side DeckDriver PCB ...............................8-452. Removing the OPEN SwitchPCB ..........................................8-45I. SELECTING THE SITE ......................9-1II. UNPACKING AND INSTALLING ........9-4A. Unpacking......................................9-5B. Installing the Scanner....................9-7C. Installing the Fixing Assembly .......9-8D. Installing the AP Kit and theCharging Assemblies.....................9-10E. Installing the Copy Tray .................9-161. Replacing the Delivery RollerLeaf Spring ...............................9-16F. Checking the DevelopingAssembly .......................................9-17G. Installing the Pick-Up Assembly ....9-19H. Supplying Toner .............................9-21I. Connecting the PDF Connector ....9-25J. Image/Operation Checks andUser Mode .....................................9-26K. Image/Operation Checks and UserMode..............................................9-30III. RELOCATING THE MACHINE ...........9-31IV. INSTALLING THE CONTROLCARD V ..............................................9-32V. INSTALLING THE COPY DATACONTROLLER-A1..............................9-40A. Setting the Board...........................9-40B. Installing to the Copier ..................9-44C. Checking the Operation.................9-46VI. INSTALLING THE REMOTEDIAGNOSTIC DEVICE II....................9-56A. Installation to the Copier ...............9-56CHAPTER 9 INSTALLATION
