15. Removing the Side Guide PlateAssembly1) Mark the position of the side guideplate with a pencil or the like. (SeeFigure 5-902.)2) Remove the two mounting screwsq, and disconnect the two connec-tors; then, remove the side guideplate assembly w.16. Removing the Holding Tray X Motor1) Remove the side guide plateassembly.2) Remove the mounting screw, andremove the motor cover.3) Remove the two mounting screwsq, and disconnect the connector;then, remove the motor w.17. Removing the Holding Tray Re-Circulating Motor1) Remove the side guide plateassembly.2) With the paper jogging guide platefully open, mark the position of thepaper jogging guide plate assemblywith a pencil or the like. (See Figure5-901.)3) Remove the three mounting screwsq, disconnect the connector w,and remove the E-ring e; then,remove the rear guide plate assem-bly r.CHAPTER 5 PICK-UP/FEEDING SYSTEM5-105COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Figure 5-894qqwFigure 5-895qwFigure 5-896qqwer
