L. Hopper Assembly1. Removing the Hopper Assemblyfrom the Copier1) Remove the developing assemblyfrom the copier. (See p. 4-57.)2) Slide out the hopper assembly tothe front. (See p. 7-17.)3) Remove the mounting screw q, andremove the stopper w; then,remove the hopper assembly e.M. Drum Cleaner1. Construction2. Removing the Cleaning Blade1) Slide out the process unit from thecopier. (See p. 7-18.)2) Remove the primary chargingassembly.3) Disconnect the connector q on theAC line of the drum heater.4) Remove the four mounting screwsw, and remove the cleaning bladeassembly e.CHAPTER 4 IMAGE FORMATION SYSTEM4-62 COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Figure 4-347qweFigure 4-348Cleaning bladeSeparation clawFigure 4-349ww e q
