CHAPTER 3 EXPOSURE SYSTEM3-31COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)B. Lens Drive AssemblyIf you turn on the power supply with-out removing the lens metal fixing of thelens stage or move the lens or the lensstage without disconnecting the powerplug, you can damage the gear of theoutput shaft.a. Be sure to remove the lens metalfixing of the lens stage before con-necting the power plug wheninstalling the machine.b. Be sure to disconnect the powerplug before moving the lens stage orthe zoom lens by hand.Further, avoid moving without care,and be sure to hold the area nearthe point of engagement with therail.1. Removing the Lens Y DirectionDrive Motor1) Remove the copyboard glass retain-er, and remove the copyboard glass.2) Move the No. 1 mirror mount to theleft.3) Remove the three mounting screwsq, and remove the lens hood w.When installing the lens hood, fitthe boss of the lens hood in thecut-off of the rail; then, hook at therear while turning the lens hoodclockwise.Caution:Figure 3-515qw
