G. Fixing/Waste Toner DriveAssembly1. Construction2. Removing the Waste Toner Bottle1) Remove the two mounting screws,and remove the lower right cover;then, remove the waste toner bottletoward the multifeeder.3. Removing the Fixing/Waste TonerDrive Assembly1) Open the front door, and draw outthe process unit, the fixing/feedingunit, and the holding tray assemblyabout 10 cm from the copier.2) Remove the rear cover.3) Remove the high-voltage trans-former PCB.4) Remove the cleaner fan and thefeeding fan.5) Remove the waste toner bottle.6) Remove the spring q, and loosenthe tension pulley w; then, detachthe timing belt e.CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS7-33COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Figure 7-441Figure 7-442qwe
