2. Removing the Sensor from theHolding Tray Feeding Assembly1) Open the front cover, and slide outthe holding tray feeding assembly tothe front.2) Remove the mounting screw q, andremove the metal fixing w; then,remove the holding tray feedingsensor cover e from under theholding tray feeding assembly.Do not open the holding tray feed-ing assembly upper guide morethan it opens freely, or the stopperr will be damaged.3) Remove the two mounting screws,and disconnect the connector; then,remove the sensor assembly fromthe holding tray feeding assembly.When installing the holding trayfeeding assembly sensor cover, besure to fit the two springs into thebosses behind the holding trayfeeding assembly upper guide.CHAPTER 5 PICK-UP/FEEDING SYSTEM5-110 COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Figure 5-907qwerCaution:Caution:
