CHAPTER 11 TROUBLESHOOTING11-37E. Fixing System1. Points to Note When Installing the Fixing Heater1) Do not touch the surface of the heater.2) For both heaters, install them with the side with the longer heater wire toward thefront.3) Install the main heater (600 W) on the right and the sub heater (600 W) on the left(viewing from the front).4) Connect the heater wire on the right to the main heater and the one at the top to thesub heater (when viewing from the rear).2. Adjusting the Position of the Fixing Assembly Inlet Guide• Points to Note in the Fieldq For the position, see the diagram.w The “low” position is when the solenoid (SL16) is ON.e Make sure the difference in height of the inlet guide between front and rear is 0.5 mmor less.r To adjust the height of the inlet guide, loosen the fixing screw on the height adjust-ing support plate.t Make checks by removing the lower roller.COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)