35. Pick-up fails. (cassette pick-up)CHAPTER 11 TROUBLESHOOTING11-101COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CauseDrive gearUpper right door,Lower right doorLocking springVertical pathroller 0 clutch(CL18),Vertical pathroller 1 clutch(CL15),Vertical pathroller 2 clutch(CL17),Vertical pathroller 3 clutch(CL11),Vertical pathroller 4 clutch(CL13)Registrationroller,Drive clutchPick-upassemblyChecksSlide in and out the cassette. Isthe sound of the lifter falling andthe lifter motor turning heard?Is the drive belt attached correct-ly?Are the upper right door and thelower right door fully closed?Are the upper right door and thelower right door keeping the verti-cal path rollers 0, 1, 2, 3, and 4 inplace?Open the upper right door and thelower right door, and insert ascrewdriver into the door switch.Do the vertical path rollers 0, 1, 2,3, and 4 rotate when the CopyStart key is pressed?Is the leading edge of the copypaper as far as the registrationroller assembly?Open the upper right door and thelower right door, and insert ascrewdriver into the door switch.Does the feeding/separation rollerrotate when the Copy Start key ispressed?Step1234567YES/NONONONONONOYESYESActionSee “The lifter fails tomove up.”Attach the belt correctly.Close the doors.Check the spring usedfor locking.Check the wiring; if nor-mal, replace the clutch.See “The registrationroller fails to rotate.”Go to step 9.Cont’d
