N. Separation Claw/SeparationClaw Drive Assembly1. Removing from the Drum Unit1) Remove the process unit from thecopier. (See p. 7-18.)1. Take care not to bend the sepa-ration claw.2. Take care not to damage thephotosensitive drum.2) Remove the screw q, and removethe No. 2 insulating plate w.3) Remove the screw e, and removethe claw holder r.O. Waste Toner Feeding Assembly1) Slide out the process unit and thefixing/feeding unit from the copier.(See p. 7-18.)2) Remove the rear cover.3) Remove the cleaner fan and thefeeding fan. (See p. 7-30.)4) Remove the high-voltage trans-former PCB.5) Remove the waste toner driveassembly together with the wastetoner feeding assembly.6) Remove the mounting screw q, andremove the waste toner feedingscrew detection circuit w.CHAPTER 4 IMAGE FORMATION SYSTEM4-66 COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Caution:Figure 4-356e erqwFigure 4-357q w
