7. Routing the Lifter Cable1) Check to make sure that the lifter drive shaft and the lifter are held in place with hexwrenches q and screwdrivers w.2) Fix the cable fixing plate e in place on the lifter with two screws.3) Hook the lifter cable on the pulley r.4) Hook the ball of the lifter cable on the lifter drive shaft; then, wind it about 1.5 timesalong the groove of the pulley t. At this time, be sure that the lifter cable is taut untilthe drivers have been lifted until they stop.5) While keeping the spatial relationship, fix the pulley in place to the lifter drive shaftwith two set screws y.6) After fixing all pulleys that have been removed to the lifter drive shaft, measure thedistance (height) from the base plate of the compartment to the top face of the lifterto check that the lifter is level.Figure 8-413rrq weetteyye(rear)CHAPTER 8 PAPER DECK-A18-39COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
