M. Cassette Pick-Up DriveAssembly1. Construction2. Removing1) Open the front door, and slide outthe holding tray assembly about 10cm from the copier.2) Remove the rear cover.3) Remove the waste toner bottle.4) Remove the waste toner bottle sup-port plate.5) Remove the rear right grip assem-bly.6) Remove the DC controller PCB, anddetach the timing belt.7) Remove the two mounting screwsq each of the paper width sensor ofthe cassettes 3 and 4; then discon-nect the connector w.CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS7-41COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Figure 7-462Figure 7-463qw
