VIII. DISASSEMBLY AND ASSEMBLYHere, the copier is discussed in terms of its mechanical characteristics and operationand how to disassemble and assemble it.Be sure to observe the following for disassembly/assembly work:1. Disconnect the power plug for safety before starting disassembly/assembly work.2. Unless otherwise noted, assemble the parts by reversing the steps used to disas-semble them.3. Identify the screws by type (length, diameter) and location.4. One of the mounting screws of the rear cover is provided with a toothed washer toprotect against static electricity. Do not leave it out during assembly work.5. The screws used for grounding wires and varistors are provided with a toothed wash-er to ensure electrical continuity. Do not leave them out during assembly work.6. As a rule, do not operate the machine with any of its parts removed.7. Before sliding out the duplexing unit or the fixing assembly, check to make sure thatthe front door switch or the power switch is off.8. CAUTION: Before disassembly or reassembly work, disconnect the accessory (ifan accessory is installed) and main body power cord(s).!!CHAPTER 5 PICK-UP/FEEDING SYSTEM5-60 COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
