After stringing the wire, check tomake sure that• It is not bent or twisted in themiddle.• It is in the V-groove of the charg-ing wire positioner.9) Install the cushion at the front of thecharging wire. (This does not applyto the primary charging assembly.)10) Install the shielding plates (left,right).For other charging assemblies,install the two lids.11) Install the wire cleaner. (At this time,be sure that the cleaner is orientedcorrectly.)12) Clean the charging wire with lint-freepaper moistened with alcohol.4. Stringing the Grid Wire of thePrimary Charging Assembly1) Loosen the two mounting screwsused to keep the left and the rightshielding plates in place.2) Loosen the three mounting screwsused to keep the motor unit at thefront in place.CHAPTER 4 IMAGE FORMATION SYSTEM4-53COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Caution:Figure 4-328 Primary Charging Wire(correct) (wrong)Grid side(correct) (wrong)Figure 4-329ScrewsCaution:
