CHAPTER 11 TROUBLESHOOTING11-404. Adjusting the Fixing ClutchWhen installing the fixing clutch,make adjustments by using the setscrews e so that the gap between the41T gear q and the washer w is 0.1 to0.2 mm (about two sheets of 64 g/m2paper). At this time, be sure to fix the setscrews e in place on the cut face of theshaft r; further, be sure also to tightenthe screw on the support plate 1 tbefore tightening the screw on the sup-port 2 y.Figure 11-2460.1~0.3mmqwertyCOPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
