8) Remove the two mounting screws!3, and remove the blade !4 togeth-er with the mounting plate.9) Remove the bearing !5 at the frontand the rear, and remove thedevelop-ing cylinder !6.Do not leave fingerprints or oils onthe surface of the developing cylin-der.If any, dry wipe the surface withlint-free paper. (Do not use sol-vent.)5. Cleaning the DevelopingAssembly Anti-Stray Sheet1) Remove the developing assembly,and clean the developing assemblyanti-stray sheet q.CHAPTER 4 IMAGE FORMATION SYSTEM4-61COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Caution:Figure 4-344!3 !3!4Figure 4-345!5 !5!6Figure 4-346q
