3) Loosen the mounting screw, andmove the grid in the direction shownin Figure 4-330; then, fix it in placetemporarily.4) Free a length (about 5 cm) of wirefrom the charging wire reel (0.1 mmdia.), and form a loop at the end (2mm dia.).Reference:To form a loop, wind the wiring wirearound a hex key once; then, turnthe hex key three to four times, andtwist the wire.5) Cut the twisted charging wire(excess) with a nipper.6) Hook the loop on the stud A shownin Figure 4-331.7) After stringing it 31 runs, route itthrough section B, and give it a halfturn; then, lead it between the wash-er and the motor unit, and wind itaround the mounting screw once(clockwise), and fix it in place with amounting screw.8) Cut the excess charging wire with anipper.9) Tighten the screw loosened in step3).Turn the screw until the tension ofthe grid wire is even.Pay attention to avoid deformationand slack; if necessary, try to tightenthe mounting screw on the left/rightshielding plate at the front earlier.10) Tighten the mounting screws loos-ened in steps 1) and 2).11) Wipe the grid wire with lint-freepaper moistened with alcohol.q Check to make sure that thegrid wire is not bent or twisted.w Check to make sure that thewire is strung at equal intervals(i.e., it is in the groove of theblock).CHAPTER 4 IMAGE FORMATION SYSTEM4-54 COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Figure 4-331Stud AScrew BCaution:Figure 4-330Screw
