2. Removing the Lifter Cable1) Remove the paper deck.2) Remove the two mounting screwsq above, and loosen the twomounting screws w on the side;then, remove the deck front covere.3) Remove the two mounting screwsr inside the deck, and remove thefront and rear guide plates t.4) Mark the position of the latchassembly; then, remove the left andright mounting screws y (7 in total),and remove the latch assembly u.5) Remove the gear cover i from thefront right.CHAPTER 5 PICK-UP/FEEDING SYSTEM5-70 COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Figure 5-821wwrtqeFigure 5-822a (left)yuFigure 5-822b (right)yyui
