CHAPTER 5 PICK-UP/FEEDING SYSTEM5-47NameHolding trayfeeding assembly1 paper sensorHolding trayfeeding assembly2 paper sensorExternal deliv-ery sensorInternal deliverysensor (revers-ing assembly)Holding trayregistrationpaper sensorHolding tray inletpaper sensorHolding traypick-up sensorHoling tray re-circulating barhome positionsensorRegistrationpaper sensorType of jamDelay/station-ary jams.Delay/station-ary jams.Delay/station-ary jams.Stationaryjams.Delay/station-ary jams.Delay/station-ary jams.Delay jams.Paper onholding tray.Delay/station-ary jams.NotationPS24PS27PS30PS33PS36PS47PS49PS52NotationPS8PS9PS10PS12PS14PS15PS17PS19PS23NamePick-up vertical0 paper sensorPick-up verticalpath 3 papersensorPick-up verticalpath 4 papersensorPick-up verticalpath 1 papersensorPick-up verticalpath 2 papersensorFixing assemblyoutlet papersensorLeft deck pick-up sensorClaw jam sen-sorType of jamDelay/station-ary jams.Delay/station-ary jams.Delay/station-ary jams.Delay/station-ary jams.Delay/station-ary jams.Delay/station-ary jams.Delay/station-ary jams.Stationaryjams.COPYRIGHT © 1997 CANON INC. CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)Table 5-701The microprocessor identifies any of the following conditions as the presence of a jam:a. Copy paper is present at any of the sensors at power-on, at the end of wait-up, orduring standby.b. Copy paper does not reach a specific sensor within a specific period of time (delayjam):1. Registration roller delay jam identified by the registration paper sensor (PS23)
