Chapter 22-15F-2-652) Attach the Toner Bottle warning label [1] of the appropriate languagebehind [2] the front cover.F-2-66- Ferrite Core (230V model only)1) Fit the ferrite core [1] to the network cable [2].Be sure to fit the ferrite core as follows to protect against noise:- Be sure to fit it as close to the joint between the machine and the networkcable as possible.- The harness must be wound around the ferrite core once before the core isfixed in place.- The harness is not trapped by the ferrite core.F-2-67When installing the machine newly or when replacing the harness, besure not to leave behind the ferrite core.- Reversing Guide (iR3570/4570 model only)1) Fit the reversing guide [1].F-2-68- Touch pen holder/touch pen1) Peel off the backing paper, and attach the touch pen holder [1] to thecontrol panel.2) Put the touch pen [2] in the touch pen holder.F-2-692.2.12 Attaching Other Parts 0010-2915iR2230 / / iR3530 /- Service Book Holder1) Remove release paper of the double-sided tape on the rib of the servicebook folder [1], and attach the holder to the bottom plate of the pedestal.F-2-70Locations where the service book folder cannot be attached.- Inside the machine (Inner side of the front cover)- Locations where the louver is blocked.- Locations where the grips are blocked.Memo:Attach the service book holder to the left cover of the machine if the pedestalis not installed.- Lower right cover1) Attach the lower right cover [1]. (Perform this step when attaching the[2][1][2][1][1][2]
