Chapter 99-19.1 Construction9.1.1 Specifications, Control Mechanisms, and Functions 0006-6002iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N / / iR4570N / iR2230 / / / iR3530 /The machine's fixing system has the following major functions:T-9-19.1.2 Major Components 0006-6003iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N / / iR4570N / iR2230 / / / iR3530 /The machine's fixing system has the following major components:F-9-1[1] Fixing heater[2] Fixing film unit[3] Pressure roller[4] Power supply brush[5] Film sensor[6] Delivery roller[7] Fixing inside delivery sensor flag[8] Cleaning roller9.2 Basic Sequence9.2.1 Power-On Sequence 0006-6005iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N / / iR4570N / iR2230 / / / iR3530 /If the thermistor detection temperature is less than 100 deg C when the power is turned on or the sleep mode is released, the control described below is performed.1. Increases the speed of the fixing motor in phases (1/4 speed to 1/2 speed and then to normal speed).2. Performs the start-up current control.3. Performs the temperature control at 200 deg C for 10 sec.4. Stops the fixing motor. When the fixing motor is stopped, the fixing temperature control is also stopped, and the machine enters the stand-by mode.When the print preparation request is received during wait time, the control described below is performed.1. Increases the speed of the fixing motor in phases (1/4 speed to 1/2 speed and then to normal speed).2. Performs the start-up current control.3. Starts measuring the time passed after the machine reaches the target temperature T deg C.Target temperature T deg C = 200 deg C (iR3570/iR4570): 190 deg C (iR2270/iR2870)4. Starts feeding in the case of printing in plain paper mode.5. Starts feeding when 5 sec have passed after the machine reached the target temperature in the case of printing in special paper mode.Item DescriptionFixing method by fixing film + pressure rollerFixing heater plate-type heaterControl temperature 180 deg C (at PSTBY)Fixing drive control by control of fixing film speedFixing temperature detection by main thermistorProtective mechanism by sub thermistorCleaning method by cleaning roller[1][2][3][4][5][6][7] [8]
