Chapter 88-498.8.4 Sensor Mount8.8.4.1 Removing the Right Cover (rear) 0007-6558iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Open the pedestal right door [1]. (if equipped with a 2-Cassette Pedestal-Y2)2) Open the right lower door [2].3) Remove the 5 screws [3], and detach the right cover (rear) [4].F-8-1088.8.4.2 Removing the Right Door 0007-6563iR3570 / iR4570 / / iR3570N / / iR4570N / iR2230 / / / iR3530 /1) Open the right door.F-8-1092) Remove the screw [1], and detach the fixing plate [2].F-8-1103) Remove the joint shaft [1], and free the extension delivery unit [2] fromthe right door.F-8-1114) Disconnect the connector [1], and remove the reuse band [2]; then, removethe 2 screws (M4x8; RS tightening).F-8-1125) While freeing the hinge assembly [2], detach the right door.F-8-113Attaching the Right Door1) Match the hinge [1] found at the bottom of the right door against the lug.2) Engage the hinge [2] found on the top of the right door with the hookfound on the side plate.F-8-114When tightening the 2 screws used to fix the hinge in place, be sure to closethe right door first.[1][2][3][3][3][4]
