Chapter 22-55F-2-18517) Plug the cable [1] in the terminal of voice board.F-2-18618) Plug the power cable (for receptacle) of the iR host machine into a receptacle.19) Turn on the main power switch.20) Check if the voice board has been recognized.service modeCOPIER > DISPLAY > ACC-STS > PCI1If 'voice guidance board' is indicated for PCI1, the board is correctly recognized by the machine.3. Making Settings After InstallationTo make use of the Voice Guidance Kit-A2 after turning on the host machine, you need to make the following settings in Additional Function:Additional Function > System Setting > Voice Guide Manegement > Use Voice Guide.1) Select [ON].2) Press [OK].default : OFF4. Checking the Operation- To Enable1) Hold down the Reset key 3 sec or more.2) See that the copy count on the screen is enclosed in red, indicating 'Voice Guidance' is ready for use.- To Disable1) Hold down the Reset key for 3 sec or more.2.12.4 A point to keep in mind at installation 0015-1981iR3025 / / iR3025N / iR3030 / / iR3030N / iR3035 / / iR3035N / iR3045 / / iR3045N2.12.5 Checking the Contents 0015-0859iR3025 / / iR3025N / iR3030 / / iR3030N / iR3035 / / iR3035N / iR3045 / / iR3045N- In order to install this equipment, "Expansion Bus-B1" is required.- In case of installing this equipment, "Voice Operation Kit-A1" cannot be installed.[1][2][2] [1]
