|
Chapter 1616-23T-16-3116.4.2 FEEDER16.4.2.1 FEEDER List 0007-9921iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 /FEEDER >ADJUSTT-16-3216.4.3 SORTER16.4.3.1 Sorter List 0007-9953iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 /SORTER > ADJUSTT-16-33COPIER > ADJUST > MISCSub-item Description LevelIMG-DLY Entering a fine adjustment value for the image delay in the subscan directionMake a fine adjustment of the image delay in the subscan direction when image datais transferred from the controller board to the DCON board.1 -128 to 127iR2270/2270F/2870/2870F: +23 (Default)iR3570/3570F/4570/4570F: +35 (Default)If RAM on the DC controller circuit board has been cleared or the board itself hasbeen replaced, enter the value from the service label.C1/2/3/4-ADJ-YEntering a horizontal registration adjustment value for Cassette 1/2/3/4Enter the horizontal registration adjustment value for Cassette 1/2/3/4.Enter the laser writing start position on the paper picked up from Cassette 1/2/3/4,based on the registered value.An increase by +1 enlarges the front margin by 0.1mm.When clearing RAM of the DC controller PCB or replacing the PCB, enter theservice label value.2 -128 to 127 (Default:0)MF-ADJ-Y Entering a horizontal registration adjustment value for the multiple manual feed trayEnter a laser write start position for paper fed from the multiple manual feed trayaccording to the registered numeric value. 2 -128 to 127 (Default: 0)DK-ADJ-Y Entering a horizontal registration adjustment value for the side paper deckEnter a laser write start position for paper fed from the side paper deck according tothe registered numeric value. 2 -128 to 127 (Default: 0)FRAME-X Entering a fine adjustment value in the subscan direction for zoomingEnter an image zooming value in the subscan direction according to the registerednumeric value. 2 -10 to 10 (-1% to 1%)FRAME-Y Entering a fine adjustment value in the main scan direction for zoomingEnter an image zooming value in the main scan direction according to the registerednumeric value. 2 -10 to 10 (-1% to 1%)FEEDER >ADJUSTSub-item Description LevelDOCST Adjusting the front position of document image Setting a greater value delays the image fronttiming. 1 -50 to 50(Value at shipping: Factory adjustment value / Value after RAMclearance: 0)LA-SPEED Adjusting the document transport speed at feeder flow read Setting a greater value increases the speed(Reducing the image) 1 -30 to 30(Value at shipping: Factory adjustment value / Value after RAMclearance: 0)SORTER > ADJUSTSub-item Description LevelPNCH-HLE Adjusting the distance from the paper end to the punched holeposition 1 -4 to 2(Value at shipping / Value after RAM clearance: 0)
|
