Chapter 22-6Points to Make Before InstallationBe sure to go through the following before starting the work:1) If you are installing the machine after moving it from a cold to warmlocation, be sure to leave the machine unpacked for at least 2 hours so thatthe machine is fully used to the site temperature, thus avoiding imagefaults caused by condensation. (The term "condensation" refers to theformation of droplets of water on the surface of a metal object brought infrom a cold to warm place, i.e., as the result of the rapid cooling of themoisture (vapor) around the object.)2) The machine weighs about 80 kg. Be sure to work in a group of 4 personswhen lifting it.Checking the ContentsF-2-11T-2-4Check the documentation and CD against the following table:T-2-5- 230V EUR model2.2 Unpacking and Installation2.2.1 Unpacking and Removing the Packaging Materials0006-6724iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / iR3530 / / / / /1) Unpack and remove the plastic bags.- When installing a pedestal to the copier at the same time, unpack it in thesame way.2) When installing the copier on the 2-cassette Pedestal-Y2, open the rightdoor [1] of the pedestal.3) Hold the recesses [2] of the copier with 4 or more people, and place it onthe pedestal.F-2-12The maximum weight of the copier is approx. 80kg (including theDADF), so be sure to lift it with 4 or more people.Memo: When placing the copier on the cassette pedestal, be sure to align thetwo positioning pins [1] to the holes on the base plate of the copier.F-2-134) Close the right door of the pedestal (in the case of the 2-cassette Pedestal-Y2).5) Remove the packaging tapes and materials from each unit.- Front door- Right door- Manual feeder unit- Cassettes 1 and 2- Inside the cassettes 1 and 2- DADF (In the case of the model with a DADF)- Platen glass6) When installing the copier to the 2-cassette Pedestal-Y2, follow theinstallation procedure for the 2-cassette Pedestal-Y2.7) Remove the optical system fixing screw [1] at the outside of the right[1] Drum unit 1 [7] Dial label 2[2] Lower right cover 1 [8] Shut-down warming label 1[3] Adjusting screw 2 [9] Toner bottle warning label 1[4] Covering rubber 1 [10] Power cable 1[5] Service book case 1 [11] Ferrite core 1[6] Cassette size label 2Operators manual: User's GuideOperators manual CD-ROM
