Chapter 22-10F-2-3614) Mount the front cover unit [3] with the two screws [2] and mount thecovering rubber [1], which is provided with the product.F-2-37ReferenceMounting the Front Cover1) Fit the 2 claws [2] of the front cover unit [1] into the claw holes [3] of themachine.F-2-382) While matching the top [4] of the front cover unit against the machine, fitthe lower left claw [2] of the front cover unit [1] in the claw hole [3] ofthe machine.F-2-393) While matching the 2 claws [2] of the front cover unit [1], slide the frontcover unit [1] to the right.F-2-4015) Close the front cover [1].F-2-412.2.4 Securing the Copier Main Unit 0006-6767iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / iR3530 / / / / /- With a pedestal installed1) Move the copier to the location where it will be installed, and then secureit with the 4 adjuster wheels of the pedestal.- Without a pedestal installed1) Remove the cassettes 1 and 2 and tighten the adjusting screws [1] at thebase plate temporarily until the screw legs touch the bottom slightly.
