Chapter 88-73F-8-2603) Remove the 4 screws [1], and take out the pickup unit 1 [2].F-8-2618.8.13.6 Removing the Pickup Assembly 2 0007-6671iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Slide out the cassette 1/2.2) Disconnect the connector [1], and free the harness from the guide; then,remove the 4 screws [2], and detach the pickup assembly 2 [3].F-8-2628.8.13.7 Removing the Cassette Size Sensor Relay PCB0007-6672iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Remove the PCB cover [1] (snap-on).F-8-2632) Remove the cassette size sensor relay PCB [2] (3 connectors [2], 2 clamps[3]).F-8-2648.8.14 Manual Tray Assembly8.8.14.1 Removing the Right Cover (rear) 0007-6697iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Open the pedestal right door [1]. (if equipped with a 2-Cassette Pedestal-Y2)2) Open the right lower door [2].3) Remove the 5 screws [3], and detach the right cover (rear) [4].F-8-2658.8.14.2 Removing the Right Door 0007-6698iR3570 / iR4570 / / iR3570N / / iR4570N / iR2230 / / / iR3530 /1) Open the right door.F-8-2662) Remove the screw [1], and detach the fixing plate [2].[1][2][3][3][3][4]
