Chapter 22-282.8.3 Installation Procedure 0013-4838iR2270 / iR2870 / iR3570 / iR4570 / / / / / / iR3025 / / iR3025N / iR3030 / / iR3030N / iR3035 / / iR3035N / iR3045 / / iR3045N1) Open the copyboard cover/DADF.2) Remove the 2 screws, and detach the glass retainer (right) [2].3) Remove the copyboard glass (for copyboard cover) [3].4) Remove the 2 screws [4], and detach the glass retainer (left) [5].5) Remove the copyboard glass (for DADF) [6].F-2-1086) Mount the clamp [1].7) Fix the heater [3] in place using a screw [2].8) Fit the connector [4] of the heater, and fix the harness of the heater in place using the clamp [1].F-2-109How to Turn Off the Main PowerWhen turning off the main power, be sure to go through the following stepsto protect the hard disk:1) Hold down the control panel power switch for 3 sec or more.2) Follow the instructions on the shutdown sequence screen to let the mainpower switch be ready to turn off.3) Turn off the power switch.4) Disconnect the power cables (for the power outlet).When removing the copyboard glass, take care not to touch the glass surfaceand the white plate on its back. (The presence of dirt will cause a black linein the images.)Points to Note When Routing the HarnessCheck to see that the harness [1] is in contact with the reader base plate.If not, hold the harness [1] down with your hand to keep it in contact withthe reader base plate.
