Chapter 1010-25F-10-866)Remove the self-tapping screws [1] and the flat-head screw [2]; then,detach the control panel frame [3].F-10-87Routing the Harness When Mounting the Control Panel Frame1.Check to be sure that the inverter harness is routed [1] as shown in the fig-ure.F-10-882.After mounting the control panel frame, be sure to route the inverter har-ness through the edge saddle [1].F-10-8910.5.6.7 Removing the Control Panel Inverter PCB 0009-2844iR2230 / / / iR3530 /1)Disconnect the 2 connectors [1].2)Remove the 2 self-tapping screws [2], and detach the control panel inverterPCB [3].F-10-9010.5.7 Control Panel Key Switch PCB10.5.7.1 Removing the Control Panel 0007-6437iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N1) Remove the rubber cap [1], and remove the screw [2].F-10-912) Open the right door [1].F-10-923) Remove the 2 screws [1].F-10-934) Slide the control panel [1] in the direction of the arrow.
