Chapter 1313-113.1 Image Adjustments13.1.1 Standards for Image Position 0007-4812iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 /A print made at a magnification of 100% must meet the following standardsfor image margin/non-image width:- Margin Along the Leading EdgeF-13-1- Left/Right Image MarginF-13-2- Leading Edge Non-Image WidthF-13-3- Left/Right Non-Image WidthF-13-413.1.2 Adjusting the Image Position 0007-4813iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 /Using the source of paper indicated, make 10 prints each to see if the imagemargin and the non-image margin are as indicated:[1] Cassettes[2] Manual feed tray[3] Side paper deckIf not as indicated, adjust the image position as follows:1.Adjusting the Leading Edge Image MarginAdjust the registration in service mode:COPIER > ADJUST > FEED-ADJ > REGISTF-13-52. Adjusting the Left/Right Image (1st side)Mechanical Horizontal Registration Adjustment3. Adding the Left/Right Image Margin (2nd side)Adjust the horizontal registration in service mode.- Small SizeCOPIER > ADJUST > FEED-ADJ > ADJ-REFEF-13-6- Large Size (longer than A4/LTR in feed direction)COPIER > ADJUST > FEED-ADJ > ADJ-RE-LF-13-74. Adjusting the Leading Edge Non-Image WidthUse service mode to make adjustments:COPIER > ADJUST > ADJ-XY > ADJ-XF-13-85. Adjusting the Left/Right Non-Image Width2 54 6 8 10 12 14 16 18 2002.5 1.5mm2nd side of double-sided copy2.5 2.0mm108654202.5 1.5mm2nd side of double-sided copy2.5 2.0mm2 54 6 8 10 12 14 16 18 2002.5 1.5mm2nd side of double-sided copy2.5 1.5mm108654202.5 1.5mm2nd side of double-sided copy2.5 1.5mmPaperleading edgeDecrease the REGIST setting.(a decrease of '10' willincrease the margin by 1 mm)Increase the REGIST setting.(an increase of '10' willincrease the margin by 1 mm)2 54 6 8 10 12 14 16 18 2001st side of copy : 2.5 1.5mmImage left edgeIncrease theADFJ-REFE value.(an increase of '10' willincrease the non-imagewidth by 1 mm)Decrease theAD-J-REFE setting.(a decrease of '10' willdecrease the non-imagewidth by 1 mm)108654202nd side ofsmall-sizedouble-sidedcopy : 2.5 2.0mmPaper left edgeIncrease theADJ-RE-L setting.(an increase of '1' willdecrease the marginby 0.1 mm)Decrease theADJ-RE-L setting(a decrease of '1' willincrease the marginby 0.1 mm)108654202nd side of large-sizedouble-sided copy: 2.5 2.0mmImage leadingedgeDecrease the ADJ-X setting.(a decrease of '10' will decreasethe non-image width by 1 mm)Increase the ADJ-X setting.(an increase of '10' willincrease the non-imagewidth by 1 mm)2 54 6 8 10 12 14 1618 2001st side : 2.5 1.5mm(2nd side of double-sided copy: 2.5 1.5mm)
