Chapter 88-90F-8-368Pickup Unit 1F-8-369Pickup Unit 22) Disconnect the connector [1], and remove the screw; then, detach thecassette pickup solenoid [3].3) Remove the bushing and the 5 screws [4]; then, detach the sensor base [5].F-8-3708.8.21.8 Removing the Vertical Path Roller 0007-6743iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Free the claw [A] of the gear [1] at the rear; then, detach the gear and thebushing [2].F-8-3712) Free the claw [A] of the bushing [1] at the front; then, shift it to the rear,and lift the vertical path roller [2] to detach.F-8-3728.8.22 Duplex Feed Roller 28.8.22.1 Removing the Right Cover (rear) 0007-6744iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Open the pedestal right door [1]. (if equipped with a 2-Cassette Pedestal-Y2)2) Open the right lower door [2].3) Remove the 5 screws [3], and detach the right cover (rear) [4].F-8-3738.8.22.2 Removing the Right Door 0007-6746iR3570 / iR4570 / / iR3570N / / iR4570N / iR2230 / / / iR3530 /1) Open the right door.[1][2][3][3][3][4]
