Chapter 1010-33F-10-14310.5.11.4 Removing the Accessories Power Supply PCB0007-6373iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / iR3530 /1) Disconnect the connector J640 [1].F-10-1442) Remove the 6 connectors [1], and free the harness from the cable clamp[2].F-10-1453) Remove the 5 binding screws [1], and detach the accessories power supplyPCB [2].F-10-14610.5.12 High-Voltage PCB10.5.12.1 Removing the Front Cover Unit 0007-8021iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Open the front cover [1].F-10-1472) Remove the face cover rubber [1].3) Remove the binding screw [2].4) Remove the RS tightening screw [3].5) Detach the front cover unit [4] by moving it in the direction of the arrow.F-10-14810.5.12.2 Removing the Waste Toner Case 0007-8028iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Remove the waste toner case [1].F-10-149Point to note after attaching the waste toner receptacleAfter attaching the waste toner receptacle, move the waste toner full detec-tion lever [1] up and down to make sure that the lever is moved smoothly.Faulty detection may be resulted if the lever is caught in something and is notmoved smoothly.F-10-150
