Chapter 99-59.4.2 Detecting an Error 0006-6013iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /As part of its protective mechanism, the machine checks for the following er-ror conditions:T-9-39.5 Parts Replacement Procedure9.5.1 Fixing Unit9.5.1.1 Removing the Right Cover (rear) 0007-7874iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Open the pedestal right door [1]. (if equipped with a 2-Cassette Pedestal-Y2)2) Open the right lower door [2].3) Remove the 5 screws [3], and detach the right cover (rear) [4].F-9-69.5.1.2 Removing the Right Door 0007-7879iR3570 / iR4570 / / iR3570N / / iR4570N / iR2230 / / / iR3530 /1) Open the right door.F-9-72) Remove the screw [1], and detach the fixing plate [2].F-9-83) Remove the joint shaft [1], and free the extension delivery unit [2] fromthe right door.Error code Detail code Symptom DescriptionE000 0000 The fixing temperature failsto increase.In the course of start-up control, the thermistor readingis less than 30 deg C 1 sec after the start of power supplyor is less than 70 deg C 2 sec after the start of powersupply; the machine will identify an error condition ifany of the foregoing continues for 200 msec or more.E001 0000 The thermistor detectsoverheating.The thermistor detects 235 deg C for 200 msec or morecontinuously.0001 A hardware circuit detectsoverheating.A hardware circuit detects overheating in relation to thethermistor (main or sub).0002 The sub thermistor detectsoverheating.The thermistor detects 295 deg C or more for 200 msecor more continuously.E002 0000 The fixing temperature failsto reach a specific level.In the course of start-up control, the thermistor detects atemperature lower then 115 deg C for 200 mseccontinuously after it has detected 100 deg C; thethermistor detects a temperature less than 150 deg C for200 msec or more continuously after it has detected 140deg C; or, the thermistor detects a temperature lowerthan 165 deg C for 20 msec or more continuously 1 secafter it has detected 160 deg C.E003 0000 The fixing temperature hasdropped to an abnormallylow level.In the course of normal temperature control, thethermistor detects a temperature lower than 140 deg Cfor 20 msec or more continuously.E007 0000 The fixing film rotates in anabnormal way.The reading of the main thermistor is in excess of 100deg C with the fixing motor in a locked state and, inaddition, the machine fails to detect the marker signalfor 6 sec.E014 0000 The machine detects afixing motor error.During operation, the machine detects an overloadcondition continuously for 3 sec or more.[1][2][3][3][3][4]
