Chapter 77-42F-7-2332) Disconnect the 3 connectors [1] found at the front and the connector [2]found at the rear.F-7-2343) Open the 11 wire saddles [1], and pull out the harness [3] through the hole[2] in the plate.F-7-2354) Remove the 3 screws [1], and detach the hopper assembly [2].F-7-236When fitting the hopper assembly to the machine, be sure that the connectors[1] are securely connected. If the connectors [1] are not connected, the envi-ronment heater will not be supplied with power, leading to image faults.F-7-2377.12.10.12 Removing the Toner Feedscrew Motor 0007-8385iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Disconnect the connector [1].F-7-2382) Remove the screw [1], and detach the toner feedscrew motor assembly [2].F-7-2393) Remove the screw [1], and detach the toner feedscrew motor [3] from thebase.F-7-2407.12.11 Static Charge Eliminator7.12.11.1 Removing the Static Eliminator 0007-8428iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Open the right door [1].
