|
Chapter 1616-2416.5 FUNCTION (Operation/Inspection Mode)16.5.1 COPIER16.5.1.1 Copier List 0008-6670iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 /T-16-34T-16-35COPIER > FUNCTION > INSTALLSub-item Description LevelTONER-S Stirring toner in the developer at installation11. Select an item to reverse its display.2. "Check the Developer" is displayed.Check that the developer connector is connected.3. Press the OK key to start operation. The operation automatically stops after count-down."Check the Developer" is displayed to prevent the connector from being disconnectedwhen the developer is replaced. Therefore, this message is not necessary when themachine is shipped with the developer for installation.STRD-POS Automatically adjusting the CCD read position at flow read- This is necessary when DF is installed and when ADF is removed and mounted again.11) Select an item to reverse its display. Then press the OK key.- Adjustment automatically starts and stops.2) Since the value is updated in the service mode, COPIER>ADJUST>ADJ-XY>STRD-POSenter the value into the service label.CARD Installing and setting the card reader1Enter the card number (1 to 2001) and press the OK key. (One thousand cards can beused from the input card number.)Then the card management information (department ID and PIN) is initialized.E-RDS Setting whether or not to use Embedded RDS10: Do not use E-RDS (Default)1: Use E-RDS (Sending all counter information)RGW-PORT Specifying the port number of the dealer server for use by Embedded RDS11 to 65535 (Default: 433)COM-TEST Checking connection to the dealer server for use by Embedded RDS11) Select an item to reverse its display. Then press the OK key.2) The connection is checked and OK or NG is displayed.OK: Connected, NG: Not connectedCOM-LOG Displaying the detailed results of testing connection to the dealer server for use byEmbedded RDS11) Select an item to reverse its display. Then press the information display field.Maximum log count: 30Display contents: Date, time, error code, and error detail information (128 charactersmax.)RGW-ADR Specifying the URL of the dealer server for use by Embedded RDS11) Select an item to reverse its display. Then press the information display field.2) The URL input screen is displayed. After input, press the OK key.Default: http://a01.ugwdevice.net/ugw/agentif010COPIER > FUNCTION > CCDSub-item Description LevelCCD-ADJ Automatically adjusting CCD11) Place about 10 or more sheets of standard white paper (whitest paper used by theuser, excluding color print paper) on the document table.2) Select to reverse its display. Then press the OK key.3) Adjustment is executed automatically (about 15 seconds). During adjustment, is displayed at the upper right of the screen.4) The LED lamp (for document lighting) lights twice and the automatic adjustmentends with displayed on the screen.5) Since all items are updated in this service mode (COPIER>ADJUST>CCD), enterthe values into the service label.
|
