Chapter 22-14large paper: A3, A4R, B5R, and the like whose length in feed direction islonger than LTR.1) Put small paper in the cassette 1 and large paper in the cassette 2.2) Make a double-sided copy using the cassette 1, and check to be sure thatthe left margin L1 of the image on the 2nd side is 2.5 +/-2.0 mm.F-2-59[1]Paper feed direction3) If not as indicated, change the small paper 2nd side horizontal registrationsetting.small paper: service mode COPIER>ADJUST>FEED-ADJ>ADJ-REFAn increase of '1' will increase the left margin of the image by 0.1 mm.4) Enter the new value (obtained as the result of the foregoing adjustment)as the large paper 2nd side horizontal registration setting.Large paper: service mode COPIER>ADJUST>FEED-ADJ>ADJ-RE-L.5) Make a double-sided copy using the cassette 2, and check to make surethat the left margin of the image on the 2nd side is 2.5 +/-2.0 mm.F-2-60[1]Paper feed detection6) If not as indicated, change the large paper 2nd side horizontal registrationadjustment setting.large paper: service mode COPIER>ADJUST>FEED-ADJ>ADJ-RE-LAn increase of '1' will increase the left margin of the image by 0.1 mm.- Leading edge marginMake a copy using the cassette 1, and check to be sure that the leading edgemargin L1 is 2.5 +/-1.5 mm. If not, be sure to make the following adjust-ments1) Make the following in service mode: COPIER >ADJUST >FEED-ADJ>REGIST.2) Change the setting to make adjustments. (A change of '1' made to thesetting will cause a move of 0.1 mm. A lower setting will move the imagetoward the leading edge.)F-2-612.2.11 Attaching Other Parts 0007-5087iR2270 / iR2870 / iR3570 / iR4570 / / / /- Service Book Holder1) Remove release paper of the double-sided tape on the rib of the servicebook folder [1], and attach the holder to the bottom plate of the pedestal.F-2-62Locations where the service book folder cannot be attached.- Inside the machine (Inner side of the front cover)- Locations where the louver is blocked.- Locations where the grips are blocked.Memo:Attach the service book holder to the left cover of the machine if the pedestalis not installed.- Lower right cover1) Attach the lower right cover [1]. (Perform this step when attaching themachine to the 2-level cassette pedestal Y2 or more.)F-2-63- Shut-Down Warning Label1) Attach the Shut-Down warning label [1] of the appropriate language to theright cover (rear) of the machine (i.e.,. on the left inside [2] of the mainpower supply.).F-2-64- Toner Bottle Warning Label1) Open the front cover [1].imageL1[1]imageL1[1]L1[2][1]
