Chapter 1515-2415.6 Finisher/Saddle Finisher Error Codes15.6.1 Error Code in Detail (finisher, puncher) 0008-1518iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N / / iR4570NT-15-1805 ADF general 0001000200030004000500060007000800090010Upper limit of the post-separation sensor exceeds the specifiedvalueLower limit of the post-separation sensor exceeds the specifiedvalue.Upper limit of the reed sensor exceeds the specified value.Lower limit of the reed sensor exceeds the specified value.Upper limit of the delivery reversal sensor exceeds the specifiedvalue.Lower limit of the delivery reversal sensor exceeds the specifiedvalue.Insufficient light intensity of the post-separation sensorInsufficient light intensity of the read sensorInsufficient light intensity of the delivery reversal sensorThe separation alarm is continuously given.61 Finisher 0001 no staple65 Puncher 0001 punch waste case fullCode Detail code Name Detection RemedyE500 0001 fault in communicationwith the finisher(common among allfinishers)Replace the finisher controllerPCB. Replace the DC controllerPCB.E503 0002fault in communicationwith the finisher(Finisher-Q3/Q4)fault in communicationbetween finisher andsaddle unitReplace the finisher controllerPCB. Replace the saddle controllerPCB. Check the cable.0003 fault in communicationbetween finisher andpunch unitReplace the finisher controllerPCB. Replace the punch drive PCB.Check the cable.E505 0001fault in the backupmemory of the finisher(common among allfinishers)fault in the data storedin backup memoryTurn off the main power. Check thewiring of the DC controller PCBand the finisher controller, andcheck the fuse of the 24-V powersupply. Thereafter, turn the mainpower back on.0002 fault in the EEPROMdata of the punch unitReplace the punch driver PCB.Replace the finisher controllerPCB.E514 0001fault in stack deliverymotor (Finisher-S1)When the stackretaining spacer isreturned to homeposition, the belt escapehome position sensordoes not go on within1.5 sec.Replace the finisher controllerPCB. Replace the stack deliverymotor. Check the stack deliverydrive mechanism.0002 When the stackretaining spacer isshifted from homeposition, the belt escapehome position sensordoes not go off within1.5 sec.E514 0001fault in trailing edgeassist motor (Finisher-Q3/Q4)The home positionsensor does not go offeven when the trailingedge assist motor hasrotated for a specificperiod of time.Replace the finisher control PCB.Replace the trailing edge assistmotor.0002 The home positionsensor does not go oneven after the trailingedge assist motor hasrotated for a specificperiod of time.Location code Alarm Code
