Chapter 1515-3115.6.2 Error Code Detail (finisher, puncher) 0009-4183iR2230 / / iR3530 /T-15-19E5F 0001 Saddle switch error The inlet cover switchhas been identified asbeing open for 1 sec ormore after the start ofprinting or the start ofinitial rotation with thefollowing sensorsidentifying theirrespective covers asbeing closed:- inlet cover sensor(PI9S)- nt cover open/closedsensor (PI2S)- delivery cover sensor(PI3S)Or, the front overswitch (MS2S) or thedelivery cover switch(MS3S) is open.Inlet cover switch(MS1S)/front coverswitch (MS2S)/delivery cover switch(MS3S)Check the inlet cover switch. Checkthe inlet cover sensor. Check thefront cover open/closed sensor.Check the delivery cover sensor.Replace the finisher controllerPCB.E5F 0002 Saddle switch error The front cover switchhas been identified asbeing open from thestart of printing or thestart of initial rotationwith the followingsensors identifyingtheir respective coversas being closed.- inlet cover sensor(PI9S)- front cover open/closed sensor (PI2S)- delivery cover sensor(PI3S)- front cover switch(MS2S)/delivery coverswitch (MS3S)Check the front cover switch.Check the inlet cover sensor. Checkthe front cover open/closed sensor.Check the delivery cover sensor.Replace the finisher controllerPCB.E5F 0003 Saddle switch error The delivery coverswitch has beenidentified as being openafter the start ofprinting or the start ofinitial rotation of thehost machine with thefollowing sensorsidentifying theirrespective covers asbeing closed:- inlet cover sensor(PI9S)- front cover open/closed sensor (PI2S)- delivery cover sensor(PI3S)- delivery cover switch(MS3S)Check the delivery cover switch.Check the inlet cover sensor. Checkthe inlet cover sensor. Check thefront cover open/closed sensor.Check the delivery cover sensor.Replace the finisher controllerPCB.Code Detail code Items Description Remedial actionE500 0001 Finishercommunication errorReplace the finisher controllerPCB. Check the cable. Replace theDC controller PCB.E503 0003 Finisher internalcommunication errorThere is an error in thecommunicationbetween the finisherand the punch unit.Replace the finisher controllerPCB. Replace the punch driverPCB. Check the cable.E505 0001Finisher backupmemory errorThere is an error in thedata stored in thebackup memory.Turn off the main power, and checkthe following: DC controller PCBand finisher PCB wiring, 24V fuse.Thereafter, turn on the main power.0002 There is an error in thepunch unit EEPROMdata.Replace the punch driver PCB.Replace the finisher controllerPCB.Code Detail code Name Detection Remedy
