Chapter 88-51F-8-1218.8.4.7 Removing the Sensor Mounting Plate 0007-6567iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Remove the 2 TP screws [1] and the binding screw [2] from the rear of thepickup assembly, and detach the bracket [3].F-8-122Pickup Unit 1F-8-123Pickup Unit 22) Disconnect the connector [1], and remove the screw; then, detach thecassette pickup solenoid [3].3) Remove the bushing and the 5 screws [4]; then, detach the sensor base [5].F-8-1248.8.4.8 Mounting the Sensor Mounting Plate 0007-6568iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /Take care not to orient the pickup unit facing down when mounting the sen-sor base; otherwise, the gears will fall out.1) After fitting the bushing [1] to the frame, mount the gear shaft [2].F-8-1252) Fit the 6 points [A] indicated in the figure in the holes of the base; then,mount the sensor base [2] using 4 screws [1].F-8-1263) Mount the gear [1] and the E-ring [2].Be sure not to leave out the pickup solenoid [1]. When mounting it, be surethat the stop [2] is fully engaged with the cam gear [3].
