Chapter 1010-28F-10-1096)Remove the self-tapping screws [1] and the flat-head screw [2]; then,detach the control panel frame [3].F-10-110Routing the Harness When Mounting the Control Panel Frame1.Check to be sure that the inverter harness is routed [1] as shown in the fig-ure.F-10-1112.After mounting the control panel frame, be sure to route the inverter har-ness through the edge saddle [1].F-10-11210.5.7.8 Removing the Control Panel Key Switch PCB 0009-2854iR2230 / / / iR3530 /1)Remove the 5 self-tapping screws [1], and detach the control panel keyswitch PCB [2].F-10-11310.5.8 Control Panel CPU PCB10.5.8.1 Removing the Control Panel 0007-7565iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N1) Remove the rubber cap [1], and remove the screw [2].F-10-1142) Open the right door [1].F-10-1153) Remove the 2 screws [1].F-10-1164) Slide the control panel [1] in the direction of the arrow.
