Chapter 1010-38F-10-1783) Open the 11 wire saddles [1], and pull out the harness [3] through the hole[2] in the plate.F-10-1794) Remove the 3 screws [1], and detach the hopper assembly [2].F-10-180When fitting the hopper assembly to the machine, be sure that the connectors[1] are securely connected. If the connectors [1] are not connected, the envi-ronment heater will not be supplied with power, leading to image faults.F-10-18110.5.12.12 Removing the Right Cover (rear) 0007-8412iR2270 / iR2870 / iR3570 / iR4570 / / iR2270N / / iR2870N / / iR3570N // iR4570N / iR2230 / / / iR3530 /1) Open the pedestal right door [1]. (if equipped with a 2-Cassette Pedestal-Y2)2) Open the right lower door [2].3) Remove the 5 screws [3], and detach the right cover (rear) [4].F-10-18210.5.12.13 Removing the Right Door 0007-8413iR3570 / iR4570 / / iR3570N / / iR4570N / iR2230 / / / iR3530 /1) Open the right door.F-10-1832) Remove the screw [1], and detach the fixing plate [2].F-10-1843) Remove the joint shaft [1], and free the extension delivery unit [2] fromthe right door.F-10-1854) Disconnect the connector [1], and remove the reuse band [2]; then, removethe 2 screws (M4x8; RS tightening).[1][2][3][3][3][4]
